1、Photo 1 shows the rocker arms with the rocker arm pins and ball bearings installed.
圖片1顯示了搖桿武器與搖臂引腳和球軸承安裝。

2、The finished rocker arm brackets.
成品搖臂括號。

3、Some castings, such as crankshaft, rocker arm et al were produced.
已澆注了曲軸、搖臂等鑄件。

4、The downward-moving side of the rocker arm pushes on the valve stem to open the valve.
搖臂向下移動的那一邊推動氣門桿以打開氣門。

5、The rocker arm pivots on a shaft through its center
搖臂以通過它的中心為軸而旋轉。

6、The "EPG" and "ETG" parallel gripper lines utilize a double acting piston and rocker arm design.
在“電子節目指南”（兩個下巴）和“ETG的”（三下巴）爪平行線利用了雙動活塞和搖臂的設計。

7、Development of Aluminum Rocker Arm of Automobile Engine
汽車發動機鋁合金搖臂的研制

8、The push rod, as it is lifted, causes the end of the rocker arm to move up.
當推桿升起時，搖臂的端部向上移動。

9、This setup shows the radius on the end of the rocker arm brackets being cut using the rotary table.
這表明，半徑設置的結束搖臂括號被削減使用轉盤。

10、One of the heads with rocker arm brackets and spark plugs installed.
其中一名負責人與搖臂括號和火花塞安裝。

11、Remove rocker arm cover and ventilator hose (A)
卸開搖臂桿蓋和通風管（A）。

12、Rocker arm, Rocker arm shaft, Rocker assembly, Valve guide tube, Camshaft bearing Cap.
氣門搖臂，搖臂軸，搖臂總成，氣門導管，凸輪軸蓋。

13、Common defects during the rocker arm production were analyzed and some measurement was suggested.
同時，分析了搖臂鑄件在生產過程中常見的缺陷，并提出了改進措施。

14、The rocker arm on the jacket launch barge is a transition installation equipped at the stern.
導管架下水駁船搖臂是安裝在船艉的用于導管架滑移下水的過渡裝置。

15、Study and Manufacture of PM Inserted Rocker Arm for JQ Engine
JQ型無鉛汽油發動機粉末冶金搖臂鑲塊的研制

rocker arm翻譯