1、Tight spinneret again after die heating oven reached technics temp. 3 hours.
箱體加熱油爐油溫達到工藝溫度3小時之后，開始二次緊固噴絲板（熱緊）。

2、The dimension of shaped spinneret was designed and calculated by equivalent diameter analysis.
采用當量直徑法對異形噴絲板的尺寸進行設計、計算。

3、Usually the number of holes in the spinneret determines the number of filament in the yarn.
一般噴絲頭細孔的數量決定了紗中長絲的根數。

4、The experimental process and results verify the spinneret and spinning pack design is reasonable.
根據實驗過程和結果，驗證噴絲板和紡絲組件設計的合理性。

5、The tantalum spinneret is a key part in chemical fibre silk spinning_machine.
噴絲頭是化纖紡織機上的關鍵部件。

6、The recovery process of monomer smoke at strand spinneret from nylon 6 production was analyzed.
分析比較了尼龍6生產中注帶處單體煙的幾種回收方法。

spinneret翻譯