1、Reassemble the relief valve in the reverse order that it was disassembled.
按照拆卸的相反順序重新組裝安全閥。

2、Relief valve Settings should be set as low as practical.
安全閥應以實際低壓力值進行設置。

3、Check valve and relief valve on the output of the gear pump tube had better install a check valve.
止回閥與安全閥在齒輪泵的輸出管路上最好安裝一個止回閥。

4、Safety relief valve is used to protect the machine and operator shall not be adjusted.
溢流閥是用來保護機器和操作人員的安全的，不得任意調整。

5、Install a 125 PSI pressure relief valve in the cold water supply line
在冷水供應管道上安裝一個125PSI的減壓安全閥。

6、Damage or fouled relief valve seat.
安全閥閥座損壞或受到污染。

7、The relief valve may be serviced while on or off the backflow preventer valve.
可以在防回流閥上維修安全閥，或?qū)⑵鋸姆阑亓鏖y拆卸下來維修。

8、The structure and principle of needle valve cushion and relief valve cushion were introduced.
本文介紹了針閥式緩沖氣缸和溢流式緩沖氣缸的結構及工作原理。

9、Clean, adjust relief valve -, check for worn and dirty valve.
清潔，調節安全閥，檢查是否有磨損和骯臟的閥門。

10、Relief valve must be piped to a suitable drain
安全閥必須配置通向適當排泄口的排泄管道。

11、Relief valve must be piped to a suitable drain.
安全閥必須配置通向適當排泄口的排泄管道。

12、Thoroughly clean all inside surfaces of the relief valve body.
徹底清洗安全閥閥體的所有內部表面。

13、Slide one half of the splash guard into the groove on the relief valve body.
將防濺保護的一半滑動到安全閥閥體的溝槽上。

14、Vent the air gap and drain line from the relief valve in accordance with code requirements.
按照規程的要求，排出安全閥氣隙和排放管道的空氣。

15、Water discharge from the relief valve should be vented in accordance with code requirements.
從安全閥出來的排放水應該按照規程的要求進行排放。

16、Damaged or fouled relief valve seat.
安全閥閥座受到損壞或污染。

17、Remove the relief valve hose from fitting below inlet ball valve.
從進口球閥下面連接件拆卸安全閥軟管。

18、Hang the Air Gap Drain on the body of the relief valve (Fig. 2).
將氣隙排放裝置懸掛在安全閥閥體上（圖2）。

relief valve翻譯